Ultrasonic pulse velocity — velocity, quality grading and crack depth
Converts UPV transit times to pulse velocity at each test location, grades concrete quality to IS 516 (Part 5/Sec 1), flags doubtful zones, checks whether rebound hammer strength estimates are valid, and estimates crack depth by the indirect method.
References:IS 516 (Part 5/Sec 1)IS 516 (Part 5/Sec 4)IS 13311 (Part 1)
IndianCodeApplied — calculation report
| Calculation | Ultrasonic pulse velocity — velocity, quality grading and crack depth |
|---|---|
| Project | — |
| Engineer | — |
| Reference | — |
| Date |
Inputs
| Specified grade | M25 |
|---|---|
| Grading criterion | IS 516 (Part 5/Sec 1):2018 as amended — grade dependent |
| Transducer arrangement | Direct (opposite faces) — preferred |
| Path length | 300 mm |
| Transit times at each location | 64.2, 66.8, 63.5, 71.9, 65.0, 76.5 |
| Estimate crack depth (indirect method) | No |
Results meet the acceptance criteriaGoverning: (cl. IS 516 (Part 5/Sec 1))
89%max. utilisation
Mean velocity
4.433 km/s
Lowest velocity
3.922 km/s
Doubtful locations
0
Overall quality
Good
Design checks 1
| Check | Clause | Demand | Limit | Utilisation |
|---|---|---|---|---|
| IS 516 (Part 5/Sec 1) | 3.922 km/s | 3.500 km/s | 89%OK |
- Velocity
- Good limit
- Excellent limit
| Location | T (µs) | V (km/s) | Quality |
|---|---|---|---|
| 1 | 64.2 | 4.673 | Excellent |
| 2 | 66.8 | 4.491 | Good |
| 3 | 63.5 | 4.724 | Excellent |
| 4 | 71.9 | 4.172 | Good |
| 5 | 65.0 | 4.615 | Excellent |
| 6 | 76.5 | 3.922 | Good |
Detailed calculation
Pulse velocity
1
IS 516 (Part 5/Sec 1)
Quality grading
2
IS 516 (Part 5/Sec 1) as amended, grade up to M25: above 4.5 km/s Excellent; 3.5–4.5 Good; below 3.5 Doubtful.
All locations ≥ 3.5 km/s: rebound hammer strength estimates can be considered valid at these locations (IS 516 Part 5/Sec 4).
Scope, assumptions and limitations
- UPV grades concrete quality and uniformity only — it must not be used to estimate the grade of concrete.
- Indirect (surface) readings are typically lower than direct readings; use them for comparison and crack studies rather than for grading where direct access is possible.
- Readings parallel and close to reinforcement overestimate velocity; choose paths that avoid bars.