Concrete core test evaluation — equivalent cube strength and acceptance
Converts core crushing loads to core strength, corrects for length/diameter ratio, converts to equivalent cube strength and checks the IS 456 acceptance criterion (average ≥ 85% and each core ≥ 75% of the specified cube strength).
References:IS 516 (Part 4)IS 456 cl. 17.4
IndianCodeApplied — calculation report
| Calculation | Concrete core test evaluation — equivalent cube strength and acceptance |
|---|---|
| Project | — |
| Engineer | — |
| Reference | — |
| Date |
Inputs
| Specified grade | M25 |
|---|---|
| Maximum aggregate size | 20 mm |
| Cores: diameter, length after capping, failure load | 94, 188, 165; 94, 180, 158; 94, 190, 172 |
Results meet the acceptance criteriaGoverning: (cl. 17.4.3)
72%max. utilisation
Average equivalent cube strength
29.63 MPa
As % of fck
118.5 %
Lowest core
28.19 MPa
Cores tested
3
Design checks 2
| Check | Clause | Demand | Limit | Utilisation |
|---|---|---|---|---|
| 17.4.3 | 29.6 MPa | 21.3 MPa | 72%OK | |
| 17.4.3 | 28.2 MPa | 18.8 MPa | 67%OK |
| Core | d (mm) | l (mm) | l/d | Load (kN) | fcore (MPa) | k (l/d) | Equivalent cube (MPa) | ≥ 75% fck |
|---|---|---|---|---|---|---|---|---|
| 1 | 94 | 188 | 2.00 | 165.0 | 23.78 | 1.000 | 29.72 | ✓ |
| 2 | 94 | 180 | 1.91 | 158.0 | 22.77 | 0.991 | 28.19 | ✓ |
| 3 | 94 | 190 | 2.02 | 172.0 | 24.78 | 1.000 | 30.98 | ✓ |
Detailed calculation
Core strengths
1
IS 516
Acceptance — IS 456 cl. 17.4.3
2
17.4.3
17.4.3
Scope, assumptions and limitations
- The l/d correction 0.11n + 0.78 and the cylinder-to-cube factor 1.25 are the widely used relations of IS 516; IS 516 (Part 4):2018 also gives factors for core diameter and moisture condition — apply them where your specification requires.
- Cores with l/d below 1 should not be tested. Cores containing reinforcement, or with large voids, give unreliable results.