Materials (before concreting)

Sand — silt content (field test)

Quick site check for clay and silt in fine aggregate, which increases water demand and reduces strength.

Standards:IS 2386 (Part 2) — deleterious materials (laboratory)Common site practice (e.g. CPWD specifications)

Equipment

  • 250 ml graduated measuring cylinder
  • Salt solution (about 1 teaspoon of salt per 500 ml water)

Procedure

  1. Pour salt solution into the cylinder to the 50 ml mark, add sand up to the 100 ml mark, then top up with solution to 150 ml.
  2. Shake vigorously, place on a level surface and leave for 3 hours.
  3. Measure the height of the silt layer settled above the sand (V₁) and the height of sand (V₂).

Calculation

Silt content=V1V2×100 %\text{Silt content} = \dfrac{V_1}{V_2}\times 100\ \%

Results and acceptance criteria

  • A limit of 8% by volume is common on Indian sites; if exceeded, wash the sand or carry out the laboratory test of IS 2386 (Part 2) against the IS 383 limits by mass.

This page summarises the procedure for site and laboratory use. Follow the current edition of the cited standards (with amendments) and the project specification, which govern.