Materials (before concreting)

Aggregates — specific gravity, water absorption and bulking of sand

Specific gravity and absorption are needed for mix design and for correcting batch water; bulking of moist sand corrects volume batching.

Standards:IS 2386 (Part 3)

Equipment

  • Wire basket and water tank with balance for weighing in water (coarse aggregate)
  • Pycnometer or 1 l flask (fine aggregate)
  • Oven, absorbent cloth, airtight container
  • Measuring cylinder (bulking)

Procedure

  1. Soak washed aggregate for 24 hours, weigh it in water (B), surface-dry it with a cloth to the saturated-surface-dry state and weigh (A), then oven-dry and weigh (C).
  2. Bulking: fill a cylinder with moist sand loosely, note the height h₁; flood with water, stir and note the settled height h₂.

Calculation

GSSD=AA−B,Gapp=CC−B,Absorption=A−CC×100 %G_{SSD} = \dfrac{A}{A - B},\qquad G_{app} = \dfrac{C}{C - B},\qquad \text{Absorption} = \dfrac{A - C}{C}\times 100\ \%
Bulking=h1−h2h2×100 %\text{Bulking} = \dfrac{h_1 - h_2}{h_2}\times 100\ \%

Results and acceptance criteria

  • Typical specific gravity of natural aggregates 2.6–2.8; water absorption usually below 2% (IS 383 limits absorption for some uses — check the project specification).
  • Moist sand can bulk by 20–40%; correct volume batching accordingly.

This page summarises the procedure for site and laboratory use. Follow the current edition of the cited standards (with amendments) and the project specification, which govern.