Materials (before concreting)

Aggregates — sieve analysis (grading) and fineness modulus

Determines the particle size distribution of fine and coarse aggregate to check compliance with grading limits and to proportion mixes.

Standards:IS 2386 (Part 1) — methodsIS 383 — grading limits and zones

Equipment

  • IS sieves: 80, 40, 20, 16, 12.5, 10, 4.75, 2.36, 1.18 mm, 600, 300, 150 µm with pan and lid
  • Balance (0.1% of sample mass)
  • Oven (110 ± 5 °C)
  • Mechanical sieve shaker (optional)
  • Riffle box for sample reduction

Procedure

  1. Reduce a representative sample by quartering or riffling and oven-dry it.
  2. Sieve through the nest of sieves from the largest down, shaking each sieve until less than 0.1% passes in one minute.
  3. Weigh the material retained on each sieve; check that the total is within 1% of the original mass.
  4. Compute cumulative % retained and % passing for each sieve and plot the grading curve.

Calculation

FM=∑cumulative % retained on standard sieves (150 µm upward)100FM = \dfrac{\sum \text{cumulative \% retained on standard sieves (150 µm upward)}}{100}

Results and acceptance criteria

  • Fine aggregate is classified into Grading Zones I–IV (coarse to fine) by IS 383; zone IV sand is generally avoided for reinforced concrete.
  • Typical fineness modulus: fine aggregate 2.2–3.2; coarse aggregate 6–7.5.

This page summarises the procedure for site and laboratory use. Follow the current edition of the cited standards (with amendments) and the project specification, which govern.